Our version of the classic modified cast split bar riser T bars.... but with a lot of obsession for detail thrown in.
This design utilizes .120" wall 7/8" riser stock brazed into 1" 4130 collars to slim down the look while still being incredibly strong. All collars are rosette welded in 4 locations, and then silver brazed with low heat to allow the 4130 to maintain its strength while not overheating it. The top collars are blended into the stock riser with silicon bronze, and then hours of texturing to tie them in to the stock riser - like a part harley could have made back in the day.
These bars are chopper jewelry, and they come ready to powder coat, patina, or chrome as your build calls for.
10" rise, 2" pull back
Edition of 3 for Fall 2019
NOTE: the actual bars are shipped a little long on each end of the bend, compared to the photos. But even still, these are set up for a fairly narrow grip area... fitting a big master cylinder along with a factory throttle is not going to happen, this is choppers. We do it that way so that you can cut them to the length and width that feels and looks right to you and your bike and/or install an internal throttle if you’d like.